Advertisement
P12 201309003 KER755_K60-65.pdf 1C( K) ZB2319 2013.09.06
1005-001900
09
dtp
ctp
SECTION 2 Controls & Indicators (LCD Control Center) (Continued)
Programming Brew Temperature (187° – 192º F)
The brewer is preset to brew at a temperature of 192°. You can adjust this
temperature down by 5 degrees if you prefer a cooler cup of coffee, tea
or hot cocoa. Simply follow the instructions below.
Press the Menu Button five times to program the Brew
1.
Temperature feature.
The LCD Control Center will display the programming options with
2.
a small arrow next to "SET BREW TEMP" (fig. 15). Also, the temperature
192° (initial setting) will be indicated at the bottom of the LCD Control
Center to indicate the current temperature setting.
A minus sign will appear over the Small Cup Button and/or a plus sign
3 .
over the Large Mug Button. Use these buttons to raise or lower the
temperature one degree at a time.
4.
Once you have reached your desired brew
15
fig.
temperature, press the Menu Button once
to exit the programming mode. "BREW TEMP
SET" will be indicated in the LCD Control
Center if you have changed it from 192°.
To change the brew temperature again, repeat
5.
192°
steps 1 through 3 to change the temperature
up or down, remembering that the temperature
can only be between 187° and 192° .
SECTION 3
Cleaning & Maintenance
cleaning external Parts
Regular cleaning of the brewer's external components is recommended.
Never immerse the brewer in water or other liquids. The Housing and
1.
other external components may be cleaned with a damp, soapy,
non-abrasive cloth.
2.
The Drip Tray can accumulate up to 8 oz. of overflow. The Drip Tray
and Drip Tray Plate should be periodically inspected and rinsed clean.
To remove the Drip Tray Assembly, simply slide it toward you, keeping
it level at all times to avoid spilling. The Drip Tray and Drip Tray Plate
should not be placed in the dishwasher. They should be cleaned with a
damp, soapy, non-abrasive cloth and rinsed thoroughly.
cleaning the K-cup
Pack holder assembly
®
1. Cleaning the Parts –
16
fig.
Assembly can be placed onto the top shelf of a
dishwasher.
in the dishwasher.
lift the Handle and grasp the top of the K-Cup
Pack Holder with one hand while pushing up
on the bottom of the K-Cup
underneath with the other until it releases
(fig. 16). After cleaning, align the K-Cup
Holder with the opening using the two front ribs
as a guide, and snap into place from the top.
12
The K-Cup
Pack Holder
®
NOTE: Use low temperature cycles
To remove from the brewer,
®
Pack Holder from
®
Pack
®
Advertisement
