Table of Contents
Advertisement
3-6 Child lock
1. If you press the spin and condensing dry button at the same time while in the cycle, it will enter into the child lock
mode.
2. In the child lock mode, no buttons except the power button can operate.
3. In the child lock mode, 'CHL' indicates the fact that the child lock is on and 'CHL' and the remaining cycle time,
'18:88' are displayed in turns.
4. When you enter into child lock mode, press the water temperature button and the dry button at the same time to cancel
the lock.
3-7 Water discharge sequence
1. If the reset water level is reached within one minute after water discharge is started, then the standby time after reset is
30 seconds.
2. If the reset water level is reached more than one minute after water discharge starts, then the standby time after reset is
120 seconds.
3. If it fails to reach the reset water level for 10 minutes, 'OE' is displayed.
3-8 Detergent sensing
1. If no liquid detergent or softener is in the detergent container or detergent has been used less than twice, the sensor
determines that there is no detergent.
2. If makes such a decision, then the 'No detergent' or 'No softener' LED is on.
3. If it determines that there is no detergent in the early stage, then the 'No detergent' or 'No softener' LED will blink and
the buzzer sound will be heard.
4. If it determines that there is no detergent during the cycle, then the 'No detergent' or 'No softener' LED will be turned
on and the cycle will progress regardless.
5. If the liquid detergent is selected but no liquid detergent is detected in the early stage, the cycle can't progress.
6. If the powder detergent is selected but no powder detergent is detected, then the 'No detergent' LED is not turned on
and there is no buzzer sound.
45
Advertisement
Table of Contents
