Daewoo KUD-UD122RF Service Manual page 42

2) Unbalanced reference value for balanced spins
Region
1st 95RPM UB
2nd 95RPM UB
350RPM increase UB
350RPM UB
1) If the pass criterion is not met, then it is moved to the laundry pulling region.
2) The final rpm is measured at 350 rpm as shown below. Target rpm
LS
340 under
340 over
- Even if you select the strongest spin mode, as long as the LS value is greater than 340, it will only reach 820 rpm.
3) Organization of the balanced spin cycle
1. In the medium spin cycle, a max 20 times of balanced spin can be performed. If it fails to enter spin R after twenty
times of balanced spin, spin R is abandoned and it moves to the next cycle.
2. If it fails to enter spin R region after attempting 20 balanced spins in the main spin cycle, then controlled rinsing is
done once and spin B is performed twenty times.
3. If it fails to enter into spin R after 40 times of spin B including one time of controlled rinsing, the UE error message is
displayed.
4. Controlled rinsing follows the same sequence as the rinsing cycle in the standard course.
Reference (LS measurement) Unbalanced reference valve
0 ~ 430
431 ~ 730
731 ~
0 ~ 430
431 ~ 730
731 ~
0 ~ 430
431 ~ 730
731 ~
0 ~ 430
431 ~ 730
731 ~
350 RPM UB
200 ~ 25 over
20~25
20 under
200 over
200 under
40
Remark
Under 250
Under 250
Under 120
Under 250
Under 250
Under 120
Under 300
Under 250
Under 250
Under 300
Under 300
Under 300
reach available RPM
820RPM
950RPM
1030RPM
710RPM
820RPM