Buttonhole - Janome 2206 Instruction Manual

1
Janome 2206 Instruction Manual
BH
4
1
3
2
1 2
(C)
(B)
4
3
7
www.toews.com
2
3
(A)
6
5

Buttonhole

Pattern selector:
1
Presser foot:
2
3 Thread tension:
* Make a test buttonhole on a sample duplicating the
fabric, interfacing and seams of the actual garment.
* Place the button on the fabric sample and mark the
top and bottom to determine the position of buttonhole.
* Use interfacing on stretch fabrics.
z Carefully mark buttonhole length on fabric.
Place the fabric under the foot with the buttonhole
marking running toward you.
x Move the slider (A) toward you so that the top mark (C)
on the slider meets the start mark (B). Line up the
markings on the foot with the top mark on the fabric.
Note:
The scale on the slider is engraved in centimeters.
c
Set the pattern selector dial at "
Sew forward until you reach the front marking of your
buttonhole.
Stop sewing at a left stitch.
v
Set the pattern selector dial at "
Sew 5 stitches. Stop sewing at a right stitch.
b Set the pattern selector dial at "
Sew until you reach the back marking of the buttonhole.
Stop sewing at a right stitch.
n
Set the pattern selector dial at "
Sew a few bartacks and raise the needle from the fabric.
Set the pattern selector dial at a straight stitch.
Sew a few locking stitches.
m Remove the fabric from the machine and cut the sewing
thread. Insert a pin inside the bartack.
Then cut the opening with a seam ripper.
Take care not to cut the stitches.
36
(BH)
Sliding buttonhole foot
1–5
".
".
".
".
2206 Owners Manual/ User Guide