Preparation Before Use; Connection Of Power Supply; Keyboard Lid; Music Stand - SAWTOOTH ST-WDCP-88 Operation Instructions Manual

2

Connection of power supply

1. First make sure the power switch of electric grand piano is at OFF position. If not,
put the switch to OFF position.
2. Connect power cord; insert one end of power cord in AC jack of the electric grand
piano and the other end in power socket.
Warning
Be sure power voltage is AC Local voltage ±10%.Too high or low voltage will cause the
damage of the electric grand piano.
Do not pull out power cord from power socket before turning off power switch.
Fuse replacement shall only be made by qualified personnel.

Keyboard lid

■Open keyboard lid
Gently lift keyboard lid and push it to slide and open the lid.
Warning
When you open or close keyboard lid, please hold it until it is opened or closed completely.
Avoid your finger being clamped between keyboard and lid.
■Close keyboard lid
Slide keyboard lid towards your body and gentle put down the lid over keyboard.
Caution
Do not place metals or paper on keyboard lid, otherwise the small matter on keyboard lid
will probably fall into the electric grand piano and be difficult to take it out, so as to cause
electric shock, short circuit, fire or other severe damage to piano.

Music stand

■Lift music stand
Pull out music stand upwards to full reach.
Now spring will bounce out. Lower the music stand.
■Lower music stand
1.Pull out music stand upwards to full reach.
2.Fold spring inwards.
3.Gently put music stand down.

Preparation before use