Table of Contents
Advertisement
How to Wire Your Ceiling Fan - C1 Wall Control (Optional)
NOTE: If fan or supply wires are different colors than
indicated, have this unit installed by a qualified
electrician.
1. Complete steps 1 thru 3 "How to Wire Your Fan - Pull
Chain" from page 7.
2. Installing Wall Control (Figures 14 & 15):
• With electrical power still disconnected, remove the
existing wall plate and switch.
• Make wiring connections with wire nuts as shown in
Figure 11.
− One black wire from wall control unit to black
(hot supply).
− One black wire from wall control unit to black wire
leading to ceiling outlet box.
• Attach wall control unit to outlet box using the two
6-32 screws provided.
• Attach wall plate to the switch control front using the
two small screws provided.
• Restore electrical power.
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box
and not pinched between the wall plate and the wall.
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire.
operate fan until blade is in place. Noise and fan
damage could result.
Operating Instructions - C1 Wall Control (Optional)
1. Operating & Using Wall Control (Figure 16):
NOTE: Set pull chain to high speed before using the wall
control. To avoid accidental pull chain use, shorten
chain by cutting it 2 to 4 inches below switch body. You
can now use your speed control to select any of the
3-speeds plus OFF.
• 3 Slide Switch – high fan speed
• 2 Slide Switch – medium fan speed
• 1 Slide Switch – low fan speed
• OFF Switch – fan off
Do not
9
120 VAC SUPPLY
(User Supplied)
BLK
TO HOT
BLK
TO FAN
Figure 14
3
2
1
O F
F
NOTE: Supply wires and
fan wires omitted for clarity
Figure 15
3
2
1
OFF
Figure 16
Advertisement
Table of Contents
