Tools Needed For Assembly; Unpacking Instructions - Fanimation Treventi FP2500 Series Owner's Manual

This Manual is Designed to Make it as Easy as Possible for You
to Assemble, Install, Operate, and Maintain Your Ceiling Fan

Tools Needed for Assembly

•
One Phillips head screwdriver
•
One stepladder
•
One 1/4" blade screwdriver
▲WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 4). If you feel you
do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
steps have been completed and will be helpful in finding your place should you be interrupted.
▲WARNING
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not
designated for use with this product by Fanimation could
result in personal injury or property damage. Contact
your retail store for missing or damaged parts.
1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description, refer to
exploded view illustration. (Figure 18, page 13)
• Fan Motor assembly
• Cover Switch Housing with two screws
• Downrod/Hanger Ball assembly (DR6)
Fan Motor
Assembly
Cover Switch Housing
•
One wire stripper
•
Three wire connectors
(supplied)

Unpacking Instructions

Support Cable Bag
Downrod/
Hanger Ball
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
Installed Wire Length
Up to 50 ft.
50 - 100 ft.
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are missing,
contact your local retailer.
DAMP LOCATION CEILING FAN: If you have purchased a
Damp Location Ceiling Fan, you may only use light kits marked
suitable for use in damp locations.
• 3 Top Blade Holder Flanges
• Ceiling Canopy & Hanger Bracket pack
• Hardware bag:
– Two 5/32˝ threaded rods
– Two 5/32˝ lockwashers
– Two knurled knobs
– Four wire connectors
– Ten screws (for use with Top Flange Blade Holder)
– Fanimation screwdriver
• Support Cable bag:
– Ceiling Support Cable
– Cable Clamp
– ˝ x 2˝ Lag Bolt
– ˝ Flat Washer
• C22 Hand-held Remote Control
• C23 Wall Control
• Remote Module Unit
Top Flange
Blade Holders
(Set of 3)
Hanger Bracket
Ceiling Canopy
Assembly
3
Materials
Wire Size A.W.G.
14
12
Hardware Bag
HI U/L
MED D/L
LOW
REV
FAN OFF
OFF ON
C22 Remote
C23 Wall
Control
Remote Module
Unit
Control