Fanimation Treventi FP2500 Series Owner's Manual page 6

How to Assemble Your Ceiling Fan (cont'd)
The Clevis Pin must go through the holes in the Downrod
Support and the holes in the Downrod. Be sure to push
the straight leg of the Hairpin Clip through the hole near
the end of the Clevis Pin until the curved portion of the
Hairpin Clip snaps around the Clevis pin. The Hairpin
Clip must be properly installed to prevent the Clevis Pin
from working loose. Pull on the Hanger Ball to make sure
the Clevis Pin is properly installed.
5. Route wires and safety cable through opening in
Canopy. Position Canopy on fan shown with open side
facing up. (Figure 6)
6. Reinstall the Hanger Ball (Figure 7) on the Downrod
as follows. Route the two 80˝ wires and the safety cable
through the Hanger Ball. Position the Pin through the
two holes in the Downrod and align the Hanger Ball
so the Pin is captured in the groove in the top of the
Hanger Ball. Pull the Hanger Ball up tight against the pin.
Securely tighten the setscrew in the Hanger Ball. A
loose setscrew could create fan wobble.
▲WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the setscrews are securely
tightened. Failure to verify that the pin and setscrews
are properly installed could result in the fan falling.
7. While pulling up on the hanger ball, securely tighten
the two 3/16-24 x 3/8˝ setscrews in the downrod support
(Figure 6).
NOTE: The setscrews must be properly installed as
described above, or fan-wobble could result.
8. The fan comes with black, and white leads. Before
installing fan, measure up approximately 6 to 9
inches above top of Downrod/Hanger Ball Assembly.
Cut off excess wire and strip back insulation 1/2˝ from
end of wire.
9. Install three Candelabra Bulbs (not included - 40 watts
max) in each of the sockets on the Uplight Assembly
(Figure 8).
10. You have now completed the assembly of your new
ceiling fan. You can now proceed with the hanging and
the electrical wiring of your fan.
CAUTION
Do not connect fan blades until the fan is completely
installed. Hanging fan with blades connected may result
in damage to the fan blades.
Downrod
Clevis Pin
Setscrew (2)
Ceiling
Canopy
6
Hairpin
Clip
Downrod
Support
Figure 6
Downrod
Pin
Setscrew
Figure 7
Candelabra
Bulb (3)
Figure 8