How To Hang Your Ceiling Fan - Fanimation Treventi FP2500 Series Owner's Manual

Standard & damp location models

Hide thumbs Also See for Treventi FP2500 Series:

Specification sheet (2 pages)

Table Of Contents

Table of Contents

▲WARNING

To avoid possible electrical shock, be sure electricity is

turned off at the main fuse box before hanging.

NOTE: If you are not sure if the outlet box is grounded,

contact a licensed electrician for advice, as it must be

grounded for safe operation.

▲WARNING

The fan must be hung with at least 7´ of clearance from

floor to blades. (Figure 8a)

▲WARNING

The hanger bracket must be directly anchored to building

structural member and be capable of withstanding a load

of at least 100 lbs.

1. Using the

⁄

˝ x 2˝ lag bolt and flat washer, attach

safety cable to ceiling joist or wood structural member.

The lag bolt will pass through the flat washer, safety

cable loop, the junction box and into the building structure

(Figure 9). You will first drill a ¼˝ pilot hole into the

building structure to prevent splitting or cracking.

2. Securely attach the hanger bracket to ceiling junction

box acceptable for ceiling support.

NOTE: Ceiling support cable must be fastened between

flat washer and ceiling junction box (Figure 9).

INSTALLATION NOTE

If you are installing your ceiling fan on a sloped ceiling,

the hanger bracket must be mounted with the opening

parallel to the slope.

INSTALLATION NOTE

Be sure that the safety cable (along with the electrical

supply wires) is pulled through the downrod when

installing the downrod.

2. Make sure the electrical supply wires, including the

hanger bracket grounding wire and safety cable are

pulled through the downrod, between the hanger bracket

and the junction box so that electrical connections can be

made later.

3. Carefully lift the fan and seat the downrod/hanger ball

assembly on the hanger bracket that was just attached to

the ceiling joist. Be sure the groove in the ball is lined up

with tab on the hanger bracket. (Figure 10)

4. Attach the safety cable to ceiling support cable. Slide

cable clamp onto safety cable (from fan). Place the end

of cable through the loop of ceiling support cable. Pull as

much cable through loop as possible. Feed end of cable

into clamp hole and firmly tighten screw (Figure 10). Cut

off excess safety cable.