Installing The Canopy Housing; How To Install The Blades - Fanimation Treventi FP2500 Series Owner's Manual

NOTE: This step is applicable after the neccessary
wiring is completed. (see page 8 or 9)
▲WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy housing
and not pinched between the housing and the ceiling.
1. Screw in two threaded rods into the Hanger Bracket
(Figure 15a).
NOTE: The threaded rods in the hanger bracket serves
as guides for easier installation.
2. Securely attach the Canopy Housing to the Hanger
Bracket using the external lockwashers and knurled
knobs supplied with your fan (Figure 15b).
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
1. Position the palm leaf, or the wicker, or the woven
bamboo, or the wooden blade over the blade holder
flange with the threaded posts showing. Make sure the
bottom edge of the blade is fully seated against the blade
holder flange. (Figure 16)
2. Place the Blade Holder Cap on top of the blade,
positioning the holes over the threaded posts.
3. With a Philips screwdriver, thread three screws into the
posts.
4. Tighten screws to secure the blade.
5. Repeat above steps for other two blades

Installing the Canopy Housing

How to Install the Blades

NOTE: Supply wires and fan wires omitted for clarity.
Figure 15a
Screw
(3 per blade holder)
Blade Holder
Cap
Fan Blade
Lower
Blade Holder
Assembly
10
Figure 15b
Figure 16