CyberPower STANDBY UPS Series User Manual

CyberPower STANDBY UPS Series User Manual

Advertisement

Quick Links

FEATURES
1.
Power On Switch
2. Power On Indicator (green)
3. Battery and Surge Protected Outlets
4. Full-Time Surge Protection Outlets
4241 12th Avenue East, Suite 400 | Shakopee, MN 55379 | CyberPowerSystems.com
YOUR ULTIMATE ALLY IN POWER
STANDBY UPS SERIES
SL750U / SL700U
USER MANUAL
5. Circuit Breaker
6. USB Port to PC
7. Wiring Fault Indicator (red)
8. Widely-Spaced Outlets
Cyber Power Systems (USA), Inc.

Advertisement

Table of Contents
loading

Summary of Contents for CyberPower STANDBY UPS Series

  • Page 1 YOUR ULTIMATE ALLY IN POWER STANDBY UPS SERIES SL750U / SL700U USER MANUAL FEATURES Power On Switch 5. Circuit Breaker 2. Power On Indicator (green) 6. USB Port to PC 3. Battery and Surge Protected Outlets 7. Wiring Fault Indicator (red) 4.
  • Page 2: Product Registration

    PRODUCT REGISTRATION Thank you for purchasing a CyberPower product. This UPS is designed to provide unsurpassed power protection, operation, and performance during the lifetime of the product. Please take a few minutes to register your product at: www.CyberPowerSystems.com/registration. Registration certifies your product’s warranty, confirms your ownership in the event of a product loss or theft, and entitles you to free technical support.
  • Page 3: Installing Your Ups System

    INSTALLING YOUR UPS SYSTEM UNPACKING Inspect the UPS upon receipt. The box should contain the following: (a) UPS unit (b) User’s manual (c) USB device cable DETERMINE THE POWER REQUIREMENTS OF YOUR EQUIPMENT 1. Ensure that the equipment plugged into 3.
  • Page 4: Basic Operation

    BASIC OPERATION 1. Power On Switch or other large electrical device into the “Battery and Surge Protected Outlets.” To turn the UPS on, press the power button The power demands of these devices will for approximately 2 seconds - you will hear overload and possibly damage the unit.) a constant tone (1 second) - and release 4.
  • Page 5: Troubleshooting

    UPS on. Recharge the battery by leaving the UPS Battery not fully charged. plugged in. The UPS does not perform Contact CyberPower Systems about expected runtime. Battery is worn out. replacement batteries at: cyberpower- systems.com/support. The on/off switch is designed to prevent Turn the UPS off.
  • Page 6: Technical Specifications

    TECHNICAL SPECIFICATIONS Model SL700U SL750U Capacity 700VA / 370W 750VA / 375W Nominal Input Voltage 120 Vac Input Frequency 50/60 Hz ± 3 Hz On-Battery Output Voltage 120Vac ± 5% On-Battery Output Frequency 50Hz/60Hz ± 1% (auto-sensing) Max. Load for UPS Outlets 700VA / 370W 750VA / 375W Max.
  • Page 7: Fcc Compliance Statement

    State of California to cause reproductive harm and cancer. For more information, go to www.P65Warnings.ca.gov. © 2021 CyberPower Systems (USA), Inc. PowerPanel® Personal is a trademark of Cyber Power Systems(USA) Inc. All rights reserved. All other trademarks are the property of their respective owners.

This manual is also suitable for:

Sl750uSl700u

Table of Contents