Advertisement
Quick Links
Advertisement
Related Manuals for ETENON Fitness Olympic Incline Bench
Summary of Contents for ETENON Fitness Olympic Incline Bench
- Page 1 OWNER S MANUAL Olympic Incline Bench...
- Page 2 Cautions In order to avoid human injuries and property damages,before the use of this series equipment please read the following important notices 1 Before use of the equipment please read this Owner’s Manual carefully The equipment should be assembled and used strictly following the relevant instructions in this manual and can not change any of its components or disassemble it freely 2.
- Page 3 Before using the equipment please consult your physician and fitness expert and must be sure to read all the specifications in this owner s manual Manufacturer will ’ not be held responsible for any personal injury and property loss resulted from the incorrect use of the products...
-
Page 4: Fitting Instructions
Fitting Instructions 1 When strip off the wrappage around the surface of equipment should be careful do not hurt the machine with knife scratches on the surface 2 When moving this equipment a sufficient number of personnel should be used to prevent the equipment from collision or to avoid the injuries caused by personnel shortage 3 Prior to installation of the equipment make sure that all the parts are complete no... - Page 5 to check the equipment carefully identify the problems and reinstall it Warranty Ten years Main Frames One year Bushings Pivot bearings guide rods Weight plate cams swivel welding parts Pull-pin components Half year: Finish rubber grips belt cables Three Months upholstery...
-
Page 6: Assembly Step
Assembly step 1 Steps No. Description Specifications Front support frame Back upright Hex socket head cap screw M12*75 Plain washer Φ24*Φ13*2.5 Spring washer... - Page 7 Assembly step 2 Steps No. Description Specifications Turret Barbell rack Metallurgy cover Circlips for shaft d0=25...
- Page 8 Assembly step 3 Steps No. Description Specifications Front support frame Back upright Barbell rack Handle frame Hex socket head cap screw M10*100 Plain washer Φ20*Φ10.5*2 Nylon insert lock nut...
- Page 9 Assembly step 4 Step Description Specifications Front support frame Back upright Chest pad adjusting frame Semi-sliding sleeve Rotary knob Pilot plunger Spring M20 nut Limiting screw Metallurgy cover...
- Page 10 Assembly step 5 Step Description Specifications Plain washer Φ16*Φ8.4*1.6 Spring washer Hex socket head cap screw M8*40 Head pad...
-
Page 11: Exploded View
Exploded View... - Page 12 Exploded List Description Specifications Front support frame Back upright Turret Barbell rack Handle frame Chest pad adjusting frame Coupling shaft Pipe plug Round pipe plug Rubber mat Lower protecting jacket Left extend jacket Middle extend jacket Right extend jacket Rubber bumper Elliptical pipe plug Round pipe plug Handle grip...
- Page 13 Exploded List Description Specifications Hexagon socket button head screw M8*20 Hex socket head cap screw M10*100 Hex socket head cap screw M12*75 Plain washer Φ12*Φ6.4*1.6 Plain washer Φ16*Φ8.4*1.6 Plain washer Φ20*Φ10.5*2 Plain washer Φ24*Φ8.4*2 Plain washer Φ24*Φ13*2.5 Spring washer Spring washer Spring washer Nylon insert lock nut Sping clip...
- Page 14 Maintenance Attentions Daily Maintenance (Basic Maintenance) 1 Clean the seat pad back pad and cushion with warm water and soft cloth in order to avoid the sweat erosion to these component 2. Clean the frame with warm water and soft cloth. 3.