Weider XRS 20 User Manual page 12

12. Insert an M10 x 90mm Carriage Bolt (40) upward
into the Left Upright Base (9). This Bolt will be
used in a later step.
Attach the Left Upright Base (9) to the Base (7)
with two M10 x 90mm Carriage Bolts (40), an
M10 x 90mm Bolt (42), four M10 Washers (52),
and three M10 Locknuts (57); do not tighten
the Locknuts yet.
Repeat this step for the Right Upright
Base (10).
13. Attach a Storage Tube (14) to an Upright (11)
with two M10 x 90mm Bolts (42), two M10
Washers (52), and two M10 Locknuts (57).
Next, attach the Upright (11) to the Left Upright
Base (9) with the M10 x 90mm Carriage Bolt
(40), four M5 x 19mm Screws (50), and an M10
Locknut (57).
Repeat this step for the other Upright (11)
and the Right Upright Base (10).
See step 12. Tighten all of the M10 Locknuts
(57) used in step 12.
12
10
13
11
10
12
57
7
52
52
42
40
9
40
57
14
11
52
50
42
50
50
57
9
40
57