Configuring The Extremexos Switch Software - Extreme Networks ReachNXT 100-8t Quick Start Manual

Configuring the ExtremeXOS Switch Software

To initialize the ReachNXT 100-8t, perform the following steps on the uplinked ExtremeXOS switch:
1 If the ReachNXT 100-8t will be powered using Power over Ethernet (PoE) from the uplinked
ExtremeXOS switch, configure PoE on the uplinked switch, using the following commands:
enable inline-power (enabled by default)
●
show inline-power
●
configure inline-power
●
For more information about configuring PoE, refer to the ExtremeXOS Concepts Guide.
2 Enable LLDP for the port to which the ReachNXT 100-8t will be connected. Use the following
command to enable LLDP:
enable lldp ports [all | <port_list>]
3 Connect the ReachNXT 100-8t uplink port (port 9 or 9x) to the uplinked ExtremeXOS switch.
This step initializes the ReachNXT 100-8t. When initialization is complete, and the uplinked
ExtremeXOS switch is detected, the MGMT LED on the ReachNXT 100-8t lights solid green.
4 To verify that the uplinked ExtremeXOS switch detects the ReachNXT 100-8t, enter the following
command on the uplinked switch:
show lldp neighbors detailed
For an LLDP neighbor that is a ReachNXT 100-8t, the command output is similar to the following:
# show lldp neighbors detailed
--------------------------------------------------------------------------
LLDP Port 4:1 detected 1 neighbor
Neighbor: 00:04:96:1F:A8:00/9, age 29 seconds
- Chassis ID type: MAC address (4)
Chassis ID
- Port ID type: ifName (5)
Port ID
- Time To Live: 120 seconds
- System Name: "Reach 100-8t 800284-00-01 0840G-00560"
- System Description: "Reach 100-8t 1.6.1.6"
NOTE
To function, the ReachNXT 100-8t must be connected to an ExtremeXOS switch. The ReachNXT 100-8t only
operates when it detects an ExtremeXOS switch connected to the uplink port via LLDP. LLDP must be enabled on
the ExtremeXOS switch to which the ReachNXT 100-8t is connected. The ReachNXT 100-8t disables its user ports
if no ExtremeXOS switch is detected, or the uplink port is down. The user ports are re-enabled when the uplink port
is up, and an ExtremeXOS switch is detected.
4
: 00:04:96:1F:A8:00
: "9"
™
ReachNXT 100-8t Quick Start Guide