Table of Contents
Advertisement
S
ZINC PLATES ON TRIM TABS
(FIG. 6.9.1)
TRIM TABS
9. M
E
ARINE
LECTRONIC
A
S
NTICORROSION
YSTEM
®
(M
)
ERCATHODE
The automatically controlled Cathodic Anti-
Corrosion System for marine installation protects
underwater metals from the effects of corrosion and
electrolysis on stern drives.
components are designed for marine service. DO
NOT PAINT THE MERCATHODE
The anode and reference electrode are attached to
the electrode assembly under each stern drive unit.
The solid state controller is mounted within a plastic
housing on the transom in the bilge.
Maintenance
The Mercathode
system must be tested to ensure
®
adequate output. The test should be performed
every 100 hours or annually. Contact your
authorized Sea Ray
dealer to arrange for this test.
®
Refer to the engine operator's manual for more
detailed information.
240 Sundeck
®
6 • E
ECTION
ZINC ANODE
C
ATHODIC
The system
SYSTEM.
®
S
LECTRICAL
YSTEM
MERCATHODE
®
(FIG. 6.9.2)
+
–
10. E
LECTRICAL
W
H
IRING
ARNESSES
This owner's manual contains electrical schematics
and wiring harness illustrations for your boat (See
pages 6.10 thru 6.15). These electrical schematics
were generated by electrical CAD designers at the
engineering division for technical reference and
service technicians. Sea Ray
that you attempt to work on the boat's electrical
system yourself. Instead, we recommend that you
take your boat to your authorized Sea Ray
for service. Sea Ray
or update the electrical system on any model at any
time without notice to the consumer and is NOT
obligated to make any updates to units built prior to
changes.
SYSTEM
CONTROLLER
(LOCATED IN ENGINE
COMPARTMENT
ON TRANSOM)
ELECTRODE
ASSEMBLY
S
&
CHEMATICS
does not recommend
®
reserves the right to change
®
dealer
®
6.9
Advertisement
Table of Contents
