S
ECTION
4. W
S
IRING
YSTEM
•
Check all wiring for proper support.
•
Check all wiring insulation for signs of fraying
or chafing.
•
Check all terminals for corrosion - corroded
terminals and connectors should be replaced
or thoroughly cleaned.
•
Tighten all terminals securely and spray them
with light marine preservative oil.
5. F
, H
ITTINGS
OSES AND
•
Inspect the entire bilge area for evidence of
damage or deterioration. Evidence of
deterioration will first appear around hull fittings,
hoses and clamps.
•
Straighten kinked hoses.
•
Replace any hose that does not feel pliable.
•
Check all hose clamps for tightness and
corrosion. Corroded clamps must be replaced.
•
Check the nuts, bolts and screws that retain
equipment, hoses, etc. in the bilge for tightness
and corrosion. Corroded fasteners must be
replaced.
B. T
S
OPSIDE AND
UPPLIES
Once a year, you should undertake a thorough
review of the topside equipment, as well as of the
critical safety supplies on your boat.
•
Check cleats, rings, rails, etc. for loose or
corroded fasteners, breaks, sharp edges or
other conditions that could lead to malfunction
or unsafe use. Repair or replace as necessary.
•
Inspect PFDs (life jackets) for tears and
deterioration.
•
Make certain you have enough PFDs on board
for the maximum number of persons you can
carry.
240 Sundeck
®
8 • R
EQUIRED
M
AINTENANCE
C
LAMPS
I
, S
NSPECTION
•
Check your first aid kit, making certain it is
complete and that the items in it have not passed
an expiration date.
•
Check the signaling equipment and emergency
flares. Make sure all items are within their
expiration dates.
•
Inspect the anchor, mooring and towing lines.
Repair or replace as required.
•
Check fire extinguishers for full charge.
4. W
INTERIZATION
B
S
OATS
TORED ON
A. B
S
OAT
TORAGE
•
Store boat in a bow high attitude.
•
Remove hull drain plug.
•
Pour one (1) pint (half-liter) of 50% water/
antifreeze mixture in each bilge pump sump..
B. E
NGINES
•
Flush engines with fresh water.
•
Remove engine drain plugs.
REFER TO YOUR ENGINE OPERATOR'S MANUAL
FOR DETAILED INFORMATION ON PREPARING
THE
ENGINES
WINTERIZATION.
C. B
(
)
ATTERY
IES
•
Remove from boat. Remove the negative (-)
cable first, then the positive (+) cable.
•
Remove grease and dirt from top surface.
•
Grease terminal bolts.
•
Store on wooden pallet or thick plastic in a cool
ERVICE AND
C
HECKLIST FOR
L
AND
FOR
STORAGE
AND
8.5