Preparing To Depart And After Lanuching - Sea Ray 240 Sundeck Owner's Manual

Table of Contents

Advertisement

S
ECTION
Q
R
UICK
EFERENCE
B. P
REPARING TO
G
ENERAL
1. Bilge/Engine Compartment ..................................... "Sniff" the bilge/engine compartment for fuel odor.
2. Shore Power Cable ................................................ Disconnected from dockside power inlet
3. Lines, Fenders and Anchor .................................... Ready for use
4. Passengers/Crew ................................................... Instructed in duties for getting underway and fitted for a
E
NGINE
1. Battery Switches ..................................................... In the ON position
2. Fuel Valves (Diesel Only) ....................................... Opens
3. Engine Alarm .......................................................... Test. Should sound after a few seconds
4. Gear Shift & Throttle Controls ................................ In NEUTRAL and IDLE positions
S
E
TARTING THE
NGINE
1. Gearshift & Throttle Controls .................................. Shift in NEUTRAL (Refer to your Engine Owner's
2. Ignition .................................................................... Turn master ignition keys on DC distribution panel to
IMPORTANT: Do not continue to operate starter for more than 10 seconds without
pausing to allow starter motor to cool off for 2 minutes. This also will allow the battery
to recover between starting attempts.*
!
WARNING
Do not run the engine or generator in an enclosed
area, such as a closed boat house, as there is
the possibility of buildup and inhaling of carbon
monoxide.
*If engine fails to start, refer to the Engine Owner's Manual for further troubleshooting procedures
240 Sundeck
®
8 • R
EQUIRED
M
AINTENANCE
C
(
HECKLIST
CONT
D
A
EPART AND
FTER
*
I
, S
NSPECTION
'
)
D
L
AUNCHING
Run the bilge blowers for at least four (4) minutes.
correct size PFD
Manual for start-up procedures for your specific
engine)
the ON position. Depress ignition switch on the helm
switch panel to START position until engine starts, then
release to RUN position (light on).
ERVICE AND
8.11

Advertisement

Table of Contents
loading

Table of Contents