Unit Keys - Quantech QWC3050T-200T Installation Operation & Maintenance

FORM QWC3-NM1
ISSUE DATE:11/20/2020
Options Key
There are many user programmable options under the
OPTIONS key. The OPTIONS key is used to scroll
through the list of options by repeatedly pressing the
OPTIONS key. After the selected option has been dis-
played, the ↑ (UP) and ↓ (DOWN) arrow keys are then
used to change that particular option. After the option
is changed, the ENTER/ADV key must be pressed to
enter the data into memory.
Many of the OPTIONS displayed are
only programmable under the SERVICE
MODE and not under the OPTIONS key.
OPTIONS only programmable under the
SERVICE MODE are noted in the details
describing the option.
Figure 36 on page 143 shows the programmable op-
tions. Following are the displays in the order they ap-
pear:
Option 1 – Language
D I S P L A Y
E N G L I S H
English, Spanish, French, German, Italian, Portuguese,
Hungarian, Polish, and Swedish can be programmed.
QUANTECH

UNIT KEYS

OPTIONS
CLOCK
L A N G U A G E
Option 2 – QWC3 Heat Pump Mode Select
M O D E
C H I L L E R
This option will be displayed if the unit is programmed
as a chiller under the Service Mode and local/remote is
set to local.
M O D E S E L E C T
H E A T P U M P
This option will be displayed if the unit is programmed
as a heatpump under the Service Mode and local/re-
mote is set to local.
Option 3 – System Switches
only)
(Single System Display is similar)
S Y S 1 S W I T C H
S Y S 2 S W I T C H
This allows both systems to run
or
S Y S 1 S W I T C H
S Y S 2 S W I T C H
This turns system 2 OFF
S Y S 1 S W I T C H
S Y S 2 S W I T C H
This turns system 1 OFF
or
SECTION 7 – UNIT CONTROLS
00070VIP
S E L E C T
(two system units
O N
O N
O N
O F F
O F F
O N
137
7