Power Trim And Tilt Switch On Bottom Engine Cowling; Power Trim And Tilt Switches (Twin Binnacle Type); Trim Tab With Anode - Yamaha F225 Owner's Manual

Basic components
UP
DN
EMU26152
Power trim and tilt switch on bottom
engine cowling
The power trim and tilt switch is located on the
side of the bottom engine cowling. Pressing
the switch " " (up) trims the outboard motor
up, and then tilts it up. Pressing the switch
" " (down) tilts the outboard motor down and
trims it down. When the switch is released,
the outboard motor will stop in its current po-
sition.
EWM01030
WARNING
Use the power trim and tilt switch located
on the bottom engine cowling only when
the boat is at a complete stop with the en-
gine off. Attempting to use this switch
while the boat is moving could increase
the risk of falling overboard and could dis-
tract the operator, increasing the risk of
collision with another boat or an obstacle.
22
NOTE:
For instructions on using the power trim and
tilt switch, see page 48.
EMU26162
Power trim and tilt switches (twin bin-
nacle type)
The power trim and tilt system adjusts the out-
board motor angle in relation to the transom.
Pushing the switch "
ZMU03938
board motor up, and then tilts it up. Pressing
the switch "
down and trims it down. When the switch is re-
leased, the outboard motor will stop in its cur-
rent position.
UP
1. Power trim and tilt switch
NOTE:
On the dual engine control, the switch on
G
the remote control grip controls both out-
board motors at the same time.
For instructions on using the power trim and
G
tilt switches, see pages 46 and 48.
EMU26243

Trim tab with anode

The trim tab should be adjusted so that the
steering control can be turned to either the
right or left by applying the same amount of
force.
" (up) trims the out-
" (down) tilts the outboard motor
1
DN
ZMU04601