Doorphone Installation; Outdoor Camera Installation - Swann Advanced Series Quick Start Manual

The ideal installation height of the
Doorphone is about 4.7ft-5.2ft /
145-160cm from the ground.

Outdoor Camera Installation

1.64ft / 50cm
4

Doorphone Installation

5.9ft / 180cm
3.6ft / 110cm
2.48 inches / 63mm
We recommended you drill a hole in the
wall and to insert the cable before you
screw the mounting bracket on. Connect
the provided cable and power adapter to
the rear of the Doorphone (see page 5).
To mount the Doorphone, use the two
screws to secure the mounting bracket to
the wall. Make sure the four metal hooks
are pointing up. Place the Doorphone
onto the mounting plate, lining up the
four hooks with the grooves in the back of
the Doorphone. Then slide the Doorphone
down to secure it onto the hooks.
To mount the outdoor camera run the
cable from the Doorphone and pull it
through the hole you created at the
camera mounting point, and then use
the four screws to secure the mounting
bracket to the wall with the wire inside the
bracket so you can connect the camera.
Attach the cable to the rear of the outdoor
camera as shown in the wiring diagram
(see page 5). Use a small screwdriver to
push in the small button atop each wire
terminal, and then insert the wire. Place
the outdoor camera onto the mounting
bracket and slide it in top-edge first to
ensure the notches fit into the guide holes
at the top of the bracket.
To finish, secure the outdoor camera to
the mounting bracket by inserting the
screw through the bottom of the bracket
which holds it in place. Cover the hole
with the provided silicon cap.