Install The Front Bezel; Installing Screws - Dell EMC VxFlex Ready Node Installation Manual

R840 Equipment Installation
Procedure
1. Align the screws with the designated U spaces on the front and rear rack flanges.
Note: Ensure that the screw holes on the tab of the system retention bracket are seated on the designated U
spaces.
2. Insert and tighten the two screws using the Phillips #2 screwdriver to secure the rails to the cabinet.
Figure 43 Installing screws

Install the front bezel

Use this procedure to install the front bezel on the server.
Procedure
1. Align and insert the right end of the bezel onto the system.
2. Press the release button and fit the left end of the bezel onto the system.
3. Lock the bezel by using the key.
Dell EMC VxFlex Ready Node Server Installation Guide
86