Install The System In The Cabinet; Pull The Inner Rails Out Of The Cabinet - Dell EMC VxFlex Ready Node Installation Manual

Install the system in the cabinet

This procedure is used to install the system in the cabinet.
About this task
WARNING The system is heavy and should be installed in a cabinet by two people. To avoid personal injury and/or
damage to the equipment, do not attempt to install the system in a cabinet without a mechanical lift and/or help
from another person.
Procedure
1. At front of the cabinet, pull the inner slide rails out of the cabinet until they lock into place.
Figure 29 Pull the inner rails out of the cabinet
2. Locate the rear rail standoff on each side of the system. Position the system above the rails and lower the rear
rail standoffs into the rear J-slots on the slide assemblies.
3. Rotate the system downward until all the rail standoffs are seated in the J-slots.
R740XD Configuration Equipment Installation
Dell EMC VxFlex Ready Node Server Installation Guide
63