Vloss Setup Menu - EverFocus EDR410H Instruction Manual

3.6 VL s o s Setup Menu
Diagram 3.9 is a screen shot of the VLOSS (Video Loss) SETUP MENU.
VLoss event is caused by no video signal input for the channel. Usually it happens
when no power supply for the camera or the camera fails. How to set up system
response for VLoss case is introduced in this section. In the VLOSS (Video
Loss) SETUP MENU the following fields are defined as follows:
VLOSS:
ENABLE: Enable video loss detection.
DISABLE: Disable video loss detection.
DURATION: The amount of time a vloss event will record - from 1 sec
to 99 seconds. The default value is 5 seconds. To change this, simply use
the Jog Dial on the DVR. Press the Enter key to make your selection.
ALARM OUTPUT: This will transmit a signal to another device. The
setting of alarms are NONE = not activated and 1 = one output
signal transmitted. To change this, simply use the Jog Dial on the DVR.
Press the Enter key to make your selection.
ALARM EMAIL: Select "YES" for sending an email when vloss
occurs. The email address can be set in the NETWORK SETUP
MENU.
Diagram 3 .9
32