Table of Contents
Advertisement
Menu Items
Menu item details
The menu will differ depending on the input mode.
■ SCREEN ( )
AUTO (D-SUB)
The CLOCK, PHASE, H-POS, and V-POS are automatically adjusted.
CLOCK (D-SUB)
Adjusts frequency for sampling clock for applicable video.
Adjust when there is flickering in the form of vertical stripes.
When using the adjustment pattern (see page 30), make adjustments so that no vertical stripe noise appears in it.
PHASE (D-SUB)
Adjusts sampling clock phase for applicable video. Useful when small characters appear with low contrast and/or there are flickers
at corners. When using the adjustment pattern (see page 30), make adjustments so that no horizontal stripe noise appears in it.
* Adjustments to PHASE should be made only after CLOCK has been correctly set.
H-POS (D-SUB)
Adjust the horizontal position of the image.
V-POS (D-SUB)
Adjust the vertical position of the image.
BACKLIGHT OFF
When set to ON, the backlight turns off. Audio does not turn off.
SIZE
Selects screen size. (See page 20.)
RESET
Resets the values of the SCREEN menu items to the factory preset values.
Select ON and then press the ENTER button.
■ PICTURE ( )
BRIGHT
Adjusts the backlight brightness. Brightness can also be adjusted using a remote control unit. (See page 19.)
CONTRAST
Adjusts the difference between the bright and dark portions of the image.
SHARPNESS
Adjusts the sharpness of the image.
COLOR MODE
Changes the color mode on the screen. The color mode on the screen can also be changed using a remote control unit. (See
page 18.)
WHITE BALANCE
THRU .................Displays the input signal level as is.
USER.................Used for adjusting of each of red component, green component, blue component respectively using COLOR
ADJUSTMENT.
6500K/9300K .....The setting values are shown for reference. The color temperature of the screen varies over time. This
function is not intended to keep the color temperature constant.
COLOR ADJUSTMENT
Adjust item when the WHITE BALANCE is set to USER. Press the ENTER button to adjust.
RED ..........Adjusts bright-toned red component.
GREEN .....Adjusts bright-toned green component.
BLUE ........Adjusts bright-toned blue component.
GAMMA
Selects the gamma.
RGB INPUT RANGE (HDMI/DisplayPort/OPTION)
Sets the RGB input signal range.
When using HDMI, DisplayPort or OPTION set to AUTO, the RGB input signal is detected automatically. Use AUTO normally.
If the RGB input signal range cannot be set appropriately even when using AUTO, set according to the image. When the
setting is different, images will be displayed with washed out blacks and compressed gradients.
RESET
Resets the values of the PICTURE menu items to the factory preset values.
Select ON and then press ENTER button.
26
E
Advertisement
Table of Contents
