Cautionary Points; Eraser - Sharp PN-50TC1 Operation Manual

Hide thumbs Also See for PN-50TC1:

Table of Contents

Touch action

Cautionary points

• Note the following when touching by finger:

- Do not touch with a wet finger.

- Touch with the ball of your finger.

- Touch with your bare finger.

The screen will not respond if you are wearing a glove.

• Do not use the touch pen for any purpose other than touch

panel operation.

• Do not press hard on the pen tip.

• If the pen tip becomes worn or damaged, replace the touch

pen. To purchase a new touch pen, consult your dealer.

• Drawing may not be performed correctly due to the

surrounding environment, such as electromagnetic waves.

• This may not operate correctly if there is an inverter

fluorescent light nearby.

• If there is dirt or foreign matter on the tip of the touch pen,

remove it. Foreign matter may damage the screen.

• The touch pen position may occasionally deviate in the

• If the USB cable becomes disconnected, the touch

panel may not operate correctly after the USB cable is

reconnected. In this case, restart the computer.

In the Pen Software, you can erase an area of the screen that

you touch with your 5 fingers.

1. Set ERASER FUNCTION to ON. (See page 29.)

2. Change to Finger/pen mode. (See page 21.)

3. You can touch the screen with 5 fingers, and when the cursor

changes to the eraser, move your fingers.