Table of Contents
Advertisement
2.3
Positioning the Fryer
No structural material on the fryer should be altered or removed to accommodate
placement of the fryer under a hood. Questions? Call the Frymaster Dean Service
Hotline at 1-800-551-8633.
1. Once the fryer has been positioned at the frying station, use a carpenter's level placed across the
top of the frypot to verify that the unit is level, both side-to-side and front-to-back.
To level fryers, adjust the casters being careful to ensure the fryer(s) are at the proper height in
the frying station.
When the fryer is leveled in its final position, install the restraints provided by the KES to limit
its movement so that it does not depend on or transmit stress to the electrical conduit or
connection. Install the restraints in accordance with the provided instructions. If the restraints are
disconnected for service or other reasons, they must be reconnected before the fryer is used.
Adequate means must be provided to limit the movement of this appliance without
depending on or transmitting stress to the electrical conduit.
provided with the fryer. If the restraint kit is missing contact your local KES.
Hot oil can cause severe burns. Avoid contact. Under all circumstances, oil must be
removed from the fryer before attempting to move it to avoid oil spills, falls and
severe burns. This fryer may tip and cause personal injury if not secured in a
stationary position.
2. Close fryer drain-valve(s).
3. Clean and fill frypot(s) to the bottom oil level line with cooking oil. (See Equipment Setup and
Shutdown Procedures in Chapter 3.)
2.4
Installing the JIB Cradle
Open the fryer door (typically the far right door)
and remove the cross brace used for shipping
support by removing the four screws (see Figure
1). Install the JIB cradle shipped in the
accessories pack with the screws that were
removed in the cross brace removal step (see
Figure 2). If using the solid shortening option see
Appendix A in the rear of this manual for
installation instructions. Install the optional JIB
splash shield to protect the bottom of the JIB (see
Figure 3).
DANGER
DANGER
DANGER
Figure 1
Figure 3
2-4
A restraint kit is
Figure 2
Advertisement
Table of Contents
Troubleshooting
