Barco GRAPHICS 808S Isntallation Manual page 16
Hide thumbs
Also See for GRAPHICS 808S:
- Owner's manual (53 pages) ,
- Brochure & specs (2 pages) ,
- Owner's manual (55 pages)
Table of Contents
Advertisement
Installation setup
Attention : This procedure can only be done after power (mains)
connection. So, first continue with the projector setup
and the connections and then return to this procedure.
•
Switch on the projector. The projector starts up on the last
selected source.
•
Press the <ADJUST> key.
•
Highlight 'SERVICE' by pushing the control stick forward or
backward and press the <ENTER> key: the 'SERVICE MODE
MENU' will be displayed.
•
Highlight 'IDENTIFICATION' by pushing the control stick forward
or backward and press the <ENTER> key.
The projector will display the 'IDENTIFICATION SCREEN'.
This screen gives the current information about the projector
configuration in the line entitled 'Config'.
All projectors leave the factory set for a ceiling/front configuration.
4-4
All manuals and user guides at all-guides.com
ADJUSTMENT MODE
Select a path from
below:
GUIDED
RANDOM ACCESS
INSTALLATION
SERVICE
IRIS
source 1
Select with
or
then <ENTER>
<EXIT> to return
SERVICE MODE
IDENTIFICATION
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
CHANGE PASSWORD
CHANGE LANGUAGE
RUN TIME
DYNAMIC ASTIGMATISM
MORE...
Select with
or
then <ENTER>
<EXIT> to return
BS6QCD8TÃ''†
Proj. address : 001
Soft. Version : 5.00
Config. : Ceiling
front
Baudrate PC : 9600
Text : ON
Serial No. : 10359852
5975996 BARCOGRAPHICS 808s 241197
Advertisement
Table of Contents
