Replacing The Lamp; Troubleshooting - Zanussi ZOP37901XU User Manual

8. Clean the glass panels with water and soap.
Dry the glass panels carefully.
When the cleaning is completed, install the glass
panels and the oven door. Do the above steps in
the opposite sequence.
Make sure that you put the glass panels (A and B)
back in the correct sequence. The middle panel (B)
has a decorative frame. The screen-printing zone
must face the inner side of the door. Make sure that
after the installation the surface of the glass panel
frame (B) on the screen-printing zones is not rough
when you touch it.
A B C

TROUBLESHOOTING

WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem
You cannot activate or operate
the oven.
Make sure that you install the middle panel of glass
in the seats correctly.

REPLACING THE LAMP

Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
The back lamp
1. Turn the lamp glass cover counterclockwise to
remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C heat-
resistant lamp.
4. Install the glass cover.
Possible cause
The oven is not connected to
an electrical supply or it is con-
nected incorrectly.
WARNING! Danger of electrocution!
Disconnect the fuse before you
replace the lamp.
The lamp and the lamp glass cover
can be hot.
CAUTION! Always hold the halogen
lamp with a cloth to prevent grease
residue from burning on the lamp.
Remedy
Check if the oven is correctly
connected to the electrical
supply (refer to the connection
diagram if available).
A
B
C
21