Table of Contents
Advertisement
2. Lift and turn the levers on both hinges.
3. Close the oven door halfway to the first
opening position. Then pull forward and remove
the door from its seat.
4. Put the door on a soft cloth on a stable surface.
18
5. Hold the door trim (B) on the top edge of the
door at the two sides and push inwards to
release the clip seal.
2
B
6. Pull the door trim to the front to remove it.
7. Hold the door glass panel by its top edge and
carefully pull it out. Make sure the glass slides
out of the supports completely.
8. Clean the glass panel with water and soap. Dry
the glass panel carefully.
When the cleaning is completed, install the glass
panel and the oven door. Do the above steps in the
opposite sequence.
The screen-printing zone must face the inner side
of the door. Make sure that after the installation the
surface of the glass panel frame on the screen-
printing zones is not rough when you touch it.
Make sure that you install the internal glass panel in
the seats correctly.
REPLACING THE LAMP
WARNING! Risk of electric shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
1
A
Advertisement
Table of Contents
