Do's And Don'ts - Intelect NMES Instruction Manual

Table of Contents

Advertisement

6. DO'S AND DON'TS

A. DO:
1. DO place the electrodes only as your clinician recommends.
2. DO keep the stimulator clean.
3. DO see your clinician if you have any problems or questions regarding your system.
4. DO clean the cables only with water and mild soaps. DO NOT use rubbing alcohol or any other solvents.
5. DO remove the electrodes and discontinue stimulation if you experience skin irritation, until the source of that
irritation is determined by your clinician.
6. DO turn both intensity knobs to "OFF" before replacing the battery.
B. DON'T:
1. DO NOT damage your stimulator by bumping, dropping, or rough use.
2. DO NOT engage in contact sports when using your stimulator.
3. DO NOT get the stimulator wet. However, a damp cloth may be used for cleaning the outside only.
4. DO NOT pull or kink the cables.
5. DO NOT clean the cables with alcohol or any other solvents.
6. DO NOT allow electrode gel to get into the connector holes of the electrodes. DO NOT allow the electrodes
to touch each other during stimulation or improper stimulation and poor battery life will result.
7. DO NOT give the device to other individuals.
8. DO NOT store the unit at temperatures less than 32ºF (0ºC) or over 158 (50ºC).
20

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NMES and is the answer not in the manual?

Questions and answers

Doug Dicks
March 24, 2025

I purchased your device and have a question regarding the dials at the top of the unit which have numbers 1-8. Other than turning the unit on, what are they used for and what is the significance of the numbers? Thanks Doug

Table of Contents

Save PDF