Table of Contents
Advertisement
Handlebar
1. Support the handlebar, and then twist the handlebar adjust knobs
into the unlocked position.
2. Swing the handlebar forward. Prevent the cable from getting
pinched or kinked.
When unfolding the handlebar, engage and hold the blade control
lever, and then swing the handlebar into the operating position.
Turn the handlebar adjust knobs 90 degrees into the lock position
allowing the pins to spring into the holes and lock into position.
TROUBLESHOOTING
Engine Will Not Start
Possible Cause
Blade control not engaged
Fuel valve OFF
Out of fuel
Bad fuel; mower stored without
treating gasoline, or refueled with
bad gasoline
Spark plug faulty, fouled, or
improperly gapped
Spark plug wet with fuel (flooded
engine)
Fuel filter clogged, carburetor
malfunction, ignition malfunction,
valves stuck, etc.
14
BLADE CONTROL LEVER
HANDLEBAR
ADJUST
KNOB (2)
Correction
Hold blade control lever
against the handlebar
(page
7)
Turn the fuel valve ON
(page
3).
Refuel
(page
5).
Refuel with fresh gasoline
(page
5).
Gap or replace the spark plug
(page
12).
Dry and reinstall the spark
plug.
Take the mower to an
authorized Honda servicing
dealer for repair.
Loss of Power
Possible Cause
Grass is too tall
Grass is too wet
Mower deck is clogged
Air filter is clogged
Bad fuel; mower stored without
treating gasoline, or refueled with
bad gasoline
Fuel filter clogged, carburetor
malfunction, ignition malfunction,
valves stuck, etc.
Vibration
Possible Cause
Grass and debris lodged under the
mower deck
Blade is loose
Blade is bent, damaged, or
unbalanced by improper
sharpening
Mechanical damage, such as a
bent crankshaft
Mowing Problems
Possible Cause
Mower is moving too fast for lawn
conditions
Cutting height adjustment levers
set at different positions
Mower deck is clogged
Grass is too wet
Grass is too tall
Blade is dull, worn, or damaged
Wrong blade installed
Correction
Raise the cutting height
(page
4), cut a narrower
swath, push at a slower
ground speed, or cut more
frequently.
Allow the grass to dry
Clean out the mower deck
(page
13).
Clean or replace the air filter
(page
11).
Refuel with fresh gasoline
(page
5).
Take the mower to an
authorized Honda servicing
dealer for repair.
Correction
Clean out the mower deck
(page
13).
Tighten loose blade bolts
(page
10).
Take the mower to an
authorized Honda servicing
dealer for repair.
Correction
Push the mower slower.
Set all levers at the same
cutting height position
(page
4).
Clean out the mower deck
(page
13).
Allow the grass to dry
• Raise the cutting height
• Cut a narrower swath
• Use a slower ground speed
• Cut more frequently
Sharpen or replace the blade
if necessary
(page
10).
Install correct blade
(page
10).
Advertisement
Table of Contents
