Table of Contents
Advertisement
Spark Plug
Replace the spark plug every 2 years or after 150 hours of use.
Required Spark Plug: NGK - BPR5ES
NOTICE
An incorrect spark plug can cause engine damage.
For good performance, the
spark plug must be properly
gapped and free of deposits.
1. Allow the engine to cool,
disconnect the spark plug
cap, and remove any dirt
from around the spark plug
area.
2. Remove the spark plug
with a 13/16 in (21 mm)
spark plug wrench.
3. Inspect the spark plug.
Replace it if the electrodes
are worn, or if the insulator
is cracked or chipped.
4. Measure
the
spark
electrode gap with a suitable
gauge.
Gap: 0.028 ~ 0.031 in
(0.7 ~ 0.8 mm)
Correct the gap, if necessary,
by carefully bending the side
electrode.
5. Install
the
spark
carefully, by hand, to avoid
cross-threading.
6. After the spark plug seats,
tighten
with
a
13/16
(21 mm) spark plug wrench to
compress the washer
If reinstalling the old spark plug, tighten 1/8 to 1/4 turn after the
spark plug seats.
If installing a new spark plug, tighten 1/2 turn after the spark plug
seats.
Spark plug torque: 14 ft-lb (20 N·m)
NOTICE
A loose spark plug can overheat and damage the engine.
Overtightening the spark plug can damage the threads in the
cylinder head.
7. Install the spark plug cap on the spark plug.
12
SPARK PLUG
SPARK
PLUG
CAP
plug
0.028 ~ 0.031 in
(0.7 ~ 0.8 mm)
SEALING
WASHER
plug
in
Spark Arrester (optional part)
The spark arrester must be serviced every 100 hours to keep it
functioning as designed.
Your lawn mower engine is not factory-equipped with a spark arrester.
In some areas, it is illegal to operate an engine without a spark
arrester. Check local laws and regulations. An optional USDA
approved spark arrester is available from an authorized Honda
servicing dealer. See
page 18
1. Allow the engine to cool and disconnect the spark plug cap.
2. Remove the three flange bolts and the heat shield. Remove the
setscrew and the spark arrester from the muffler.
3. Check for carbon deposits on the spark arrester and the exhaust
port. Use a brush to remove any carbon deposits from the screen.
Replace the screen if it is torn or damaged.
4. Installation is the reverse of removal. Tighten all hardware
securely.
SETSCREW
BOLT (3)
MUFFLER HEAT SHIELD
Blade Control Check
1. Start the engine outdoors.
2. Release the blade control lever; the engine should stop quickly.
If it does not, take your mower to an authorized Honda servicing
dealer for repair.
BLADE CONTROL
LEVER
for part numbers.
MUFFLER
SPARK ARRESTER
Advertisement
Table of Contents
