Installing Batteries; Handling Batteries - Epson PhotoPC 600 Manual

Epson photopc 600: product information
Hide thumbs Also See for PhotoPC 600:
Table of Contents

Advertisement

EPSON PhotoPC 600
3. Plug the charger into an electrical outlet.
Both lights turn red, indicating that the charger is working.
When the batteries are fully charged, after about 2½ hours,
the lights go off.
NOTE
The charger lights flash to indicate changes in battery temperature
and voltage. If the charger lights continue to flash for more than half
an hour, the batteries may be damaged or worn out, and should be
replaced. Unplug the charger if the batteries are not fully charged
after 2½ hours.
4. When both lights are off, unplug the charger. To avoid
overcharging, don't leave the charger plugged in for long
periods of time after the lights go off.
NOTE
Make sure you charge all four batteries before you use them. If you
find that your batteries run out faster after you recharge them a few
times, make sure you discharge them completely before recharging.
If this doesn't help, replace the batteries.
5. Wait one hour until the batteries cool before removing
them from the charger.
6. Before storing the charger, press down on the prongs to lock
the plug into place.

Installing Batteries

Before you install the batteries, make sure the camera is turned
off (the lens cover is closed). Then follow these steps:
1. Turn the camera upside down with the LCD screen facing
you.
2. Push the battery cover lock down. While holding the lock,
slide the battery cover to the left to open it.
4 - EPSON PhotoPC 600
3. Insert all four batteries into the compartment, positioning
the + and - ends as shown below:
4. Close the battery cover and slide it to the right until it snaps
into place.

Handling Batteries

If you need to replace your rechargeable batteries, the camera
can also accept the following:
Rechargeable AA NiCad batteries
Single-use AA alkaline batteries (Energizer brand
recommended)
Single-use AA lithium batteries (longer life)
WARNING
To avoid the danger of fire or explosion, do not mix different types of
batteries. Replace all four batteries at the same time. Do not allow
the battery contacts to touch metal objects such as coins or keys,
which could short out the battery's circuits.Charge only with the
EPSON NiMH battery charger (Model EU-23). Do not put in fire or
water, drop or apply pressure, disassemble, short-circuit, or apply
heat. Keep away from small children. If battery acid gets into your
eyes or on your skin, immediately rinse the affected area well with
water and seek medical treatment. If a battery is swallowed, seek
medical treatment immediately.
8/97

Advertisement

Table of Contents
loading

Table of Contents