Claas ROLLANT 250 Repair Manual page 26

Drives
H
K
K
2.1.2
F
G
H
Force one bushing in the double yoke (H) through on
one side, using a tube, far enough for the grooved
yoke to make contact.
Important!
The tube must be 1 mm smaller than the bush-
ing diameter.
(Fig. 5)
5
Clamp the forced-out bushing (G) in a vise and drive it
out by light blows against the double yoke.
(Fig. 6)
6
Push the centre cross assembly (K) downward to the
stop, at the same time pushing the second bushing a
little out of the double yoke.
(Fig. 7)
7
Remove centre cross assembly (K) from the double
yoke (H) and the bushing.
(Fig. 8)
8
RHB ROLLANT 250 / 250 RC - 298 332.0