Conventional Measure; Conventional Measure In M Mode; Conventional Measure In Doppler Mode - Youkey Q7 Instructions For Use Manual

5.1 Conventional measure

5.1.1 2D Conventional measure
2D conventional measurements are suitable for regular measurements of 2D images such as B,
Color, Power and so on. The items of measurement are as follows:
Measure item
Distance
Angle
Area
Three distance
volume
Recording length
Recording area
Length ratio
Area ratio
Histogram

5.1.2 Conventional measure in M mode

M mode measurements are as follows:
Measure item Function
Measure the distance between any two points on a vertical line at a given
Distance
time.
Time Measure the time interval between two points on the M image.
The average slope between two points is calculated by measuring the distance
Gradient
and time of the two points.
On M cardiogram, the interval between two cardiac cycles was measured and
Heart rate
the heart rate was calculated.

5.1.2 Conventional measure in Doppler mode

PW mode measurements are as follows:
Measure the distance between two points on an ultrasonic image.
Measured the angle between the two intersecting planes on the ultrasonic
image.
Measure the area and perimeter of an enclosed area on an ultrasonic image.
Measure the volume of the target object.
Measure the length of a curve on an ultrasonic image.
Measure the area and perimeter of a closed curve area on the ultrasound
image.
Measure the length of the two lines on the ultrasonic image and calculate
the ratio.
Measure the area of two enclosed areas on ultrasonic images and calculate
the ratio.
Measure the gray distribution of ultrasonic echo signal in a closed area of
ultrasonic image.
Function
42