Installing memory module
1. Insert the memory module into the connector until snaps in.
2. Connect the battery cable to the connector on the system board.
3. Install the
base
cover.
4. Follow the procedures in
Heat sink
Removing heat sink assembly
Heat sink assembly consists of heat sink and the system fan.
1. Follow the procedure in
2. Remove the
base
cover.
3. Disconnect the battery cable from the connector on the system board.
4. To remove the heat sink assembly:
NOTE:
To identify the number of screws, see
a. Disconnect the fan cable from the system board [1].
NOTE:
After removing the heat sink assembly, ensure to disconnect the fan cable.
b. Remove the M2.0 x 5.0 screws that secure the heat sink and the M2.0 x 3.0 screws that secure the fan to the system
board [2].
22
Disassembly and reassembly
After working inside your
Before working inside your
computer.
computer.
screw
list.