Battery & System Test - Midtronics MDX-650P SOH Instruction Manual

When you first connect the tester to the battery, it functions as a voltmeter
until you press
Options Menu.
After you press
If any messages appear during the test, see the section "Test Messages".
1. BAT. LOCATION: Scroll to and select IN VEHICLE or OUT OF VEHICLE for a
battery not connected to a vehicle. Following an IN VEHICLE test you will be
prompted to test the starting and charging systems.
IMPORTANT: The performance of the starting and charging systems
depends on the battery's condition. It is important that the battery is
good and fully charged before any further system testing.
2. POST TYPE: (In-Vehicle only) Scroll to TOP POST, SIDE POST or JUMP START
POST where applicable.
3. APPLICATION: Scroll to and select AUTOMOTIVE, MOTORCYCLE, MARINE,
LAWN & GARDEN, GROUP 31, or COMMERCIAL -4D/8D.
4. BATTERY TYPE: Scroll to and select REGULAR FLOODED, AGM FLAT PLATE ,
EFB, AGM SPIRAL, or
STANDARD: Scroll to and select the battery's rating system. Not
5. BATTERY
all rating systems are available for each application.
Standard
CCA
CA
MCA
JIS#
EN
DIN
SAE
IEC
6. BATTERY RATING: Scroll to and select the rating units. Hold down p or q
to increase the scrolling speed.
www.midtronics.com
Battery & System Test
to start the test. This function can be turned off through the
, scroll to each parameter using p or q and press
GEL where applicable.
Cold Cranking Amps, as specified by SAE. The
most common rating for cranking batteries at 0 ºF
(–17.8 ºC).
Cranking Amps: Current available at 32 ºF (0 ºC)
Marine Cranking Amps: Amount of current
available at 32 ºF (0 ºC)
Japanese Industrial Standard, shown on a battery as
a combination of numbers and letters.
Europa-Norm
Deutsche Industrie-Norm
Society of Automotive Engineers, the European
labeling of CCA
International Electrotechnical Commission
Description
9
MDX-650P SOH
to select.
Range
100–2000
100-2000
100-2000
26A17
thru
245H52
100–2000
100–1200
100–2000
100–1200