CHAPTER 2 STANDARDS AND ADJUSTMENTS
2 Making Scanner-Related Adjustments
2.1 Routing the Scanner Drive Cable
Go through steps [1] through [7] to route the scanner cable on the pulleys and hooks:
1. Check to make sure that the scanner drive cable is free of twists and it
2. Try moving the No. 1/No. 2 mirror bases by hand to find out if they
3. Take care not to damage the cable by the edge of the metal plate.
[6]
[2]
[7]
2-2R
has not ridden over the pulleys.
move smoothly; at that time, do not touch the reflecting plate.
[6]
[2]
[3]
Secure
temporarily.
[5]
Try not to allow a gap
between runs.
Wind 7 times.
Put the metal ball
into the hole of the pulley.
F02-201-01
Wind 7 times.
[1]
Put the metal ball into
[5]
the hole of the pulley.
Try not to allow a gap
between runs.
[4]