Connect The Scanner - Epson Expression 10000XL Start Manual

Epson expression 10000xl: quick start

Hide thumbs Also See for Expression 10000XL:

Table of Contents

Connect the Scanner

Note: If you are installing the optional Network Image Express card, see the

instructions in the User's Guide.

Connect the scanner to your computer.

If you're using USB . . .

Plug the

USB port. Then plug the

on your computer or USB hub.

If you're using IEEE 1394 (FireWire

Plug one end of the IEEE 1394 cable (not included) into the scanner's

IEEE 1394 port. Then plug the other end into the IEEE 1394 port on

your computer.

Slide the transportation lock (the tab over the AC connector) up to the

Unlock position.

Plug the scanner's power cord into the AC connector. Then plug the

other end into a grounded electrical outlet.

Press the

green Ready light blinks for about 30 seconds during initialization, and

then stays on when the scanner is ready to use.

Power button

Caution

If you turn off the scanner, wait at least 10 seconds before turning

it back on.

square end of the USB cable into the scanner's

power button on the front of the scanner to turn it on. The

flat end into any available USB port

) . . .

Table of Contents