Epson ES-300C User Manual page 25

2. Select your preferred option:
Make changes to CONFIG.SYS
Write changes to file - CONFIG.ADD
If you select the first option, Setup copies your existing
CONFIG.SYS file to CONFIG.BAK before it modifies the
file.
If you select the second option, Setup copies the changes to a
file called CONFIG.ADD. You can refer to this file later to
modify your CONFIG.SYS file.
Select
3. Continue.
4. Select the bidirectional parallel option:
Bi-directional Parallel Adapter Support
Select
5. Continue.
6. Refer to the table below to select one of the options.
Epson Adapter J1-LPT1: - Address 03F8h
Epson Adapter J1-LPT2: - Address 02F8h
Most PS/2 Models - Address 038Ch
Select
J1-LPT1
J1-LPT2
PS/2
*default option
2-4 Installing Epson TWAIN
You see the Interface Options screen.
You see the Parallel Interface Options screen.
If
The jumper on your bidirectional card is set to LPT1
and you want to use LPT1 as your scanner port
The jumper on your bi-directional card is set to LPT2
(factory default) and you want to use LPT2 as your
scanner port
You are using the built-in bi-directional port on an
IBM PS/2