Monte Carlo Fan Company 3OVR60 D Series Owner's Manual And Installation Manual page 5

13
Make wiring connections using wire connectors provided as indicated above.
Red from fan to Red from receiver marked Motor U.
Purple from fan to Purple from receiver marked Motor V.
Brown from fan to Brown from receiver marked Motor W.
White from fan marked "For light" to White from receiver marked "For light".
Blue from fan marked "For light" to Blue from receiver marked "For light".
White (Neutral) from house to White from remote marked AC IN N.
Black (Live) from house to Black from remote marked AC IN L.
Connect all green grounded wires to Grounded wire from House.
Make sure that no filaments are outside of the wire connectors.
Insert the remote receiver into mounting bracket.
After making the wire connections, the wires should be spread apart with the grounded conductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on the other side of the outlet box. The splices after being made should be turned upward and
pushed carefully up into the outlet box.
14
Hump
Canopy ring
Groove
Partially loosen 2 of the set screws on
mounting bracket corresponding to the slotted
holes on the canopy upper ring. Remove the
other 2 set screws. Save screws.
Raise canopy to mounting bracket, aligning
loosened screws in mounting bracket with
slotted holes in canopy. Twist canopy
clockwise to lock. Reinstall the screws just
removed and then tighten all screw securely
Install canopy ring onto canopy by aligning the
grooves in canopy ring with the humps on
canopy and snap it onto canopy.
© 2018 Monte Carlo Fan Company
Receiver
●
●
●
15
Light pan
Attach glass to light pan by locating
dimples in light pan with grooves in glass
and twist clockwise until tight.
To Motor U- Red
To Motor V- Purple
To Motor W- Brown
To Light White
To Light Blue
Glass
5
White- AC IN N
Black- AC IN L
Receiver
120V Supply
(Power Supply)
09/2018