lavina 32R-S-E User Manual page 10

Superabrasive
CONTROL AND INDICATION UNITS ON THE ELECTRICAL CABINET
Figure 4.13
The time to move the machine without re-charging the battery is 30 minutes.
STARTING THE MACHINE
Strictly follow the instructions in chapter "SAFETY INSTRUCTOINS".
NEVER WORK WITH THE MACHINE WITHOUT HAVING VISUAL CONTACT WITH IT.
ATTENTION: Never run the machine when you are situated between the handles of the
wheel. First turn the handles as shown on Fig.4.14.
If working wet, pour water on the floor. If working on dry surface, skip that step and connect and switch on the vacuum
cleaner. Connect the machine to the electric network
and the light "POWER" will light and put the "BATTERY-LINE" switch (Fig.4.13-3 ) in
position "LINE" . Then check the "emergency stop buttons"(Fig.4.12-2 and Fig.4.13-1)
in order to be sure the machine is in working condition.
Preset the necessary rev with the switch (Fig.4.12-7) and the speed with the switch
(Fig.4.12-8).
Then start the motor by switching "Motor on" (Fig.4.12-10) and preset movement direction from the joystick
(Fig.4.12-6), by holding up the joystick for 1second in final position of the desired direction.
®
Owner's Manual – Lavina
1. Plug with closure used to connect the panel to the
machine through a cable
2. Emergency STOP button used in emergency
situations for stopping the machine. Turn on/off the panel.
3. Switch Reset
- forward position activates the initial setting on the
control panel
- back position resets the alarm of the inverters
4. Unassigned switch/button
5.Switch on/off the spotlights
6. Joystick presets the moving direction of the machine
7. Switch presets the rotation speed of the plates of the
tool holders
8. Switch presets moving speed of the machine
9. LCD – Display :
- indication of the preset rotation speed of the working
plates
- indication of the preset speed of the machine
- emergency stop button report
Figure 4.12
- report - "inverter fault"
- movement direction "forward"
- movement direction "back"
10 ON/OFF switch starts/stops the motor
11 ON/OFF switch control the water pump
1 Emergency stop button used in Emergency situations for stopping the
machine.
2 Power led lights green when the machine is connected to the current
supply and is in running line.
3 Power switch „BATTERY-LINE"
In "BATTERY" position, the machine takes power from the battery
in case it is not connected to the power supply.
In "LINE" position, the machine takes power from the electric
network and charges the battery. In this position the machine should
stay after stopping and switch-off. In case the battery is not fully
charged (after transporting it on self move) leave the machine connected to
the power supply in order to charge the battery.
11
32R-S-E 11/2014
Figure 4.14