Starting The Projector With A Password - Epson PowerLite 78 User Manual

PowerLite W6 Series: Hold down the
■
the numeric keypad to enter a four digit password.
PowerLite S6 Series or PowerLite 78: Use the numeric
■
keypad to enter a four digit password.
6. When you see a confirmation message, reenter the password.
7. Press the button, then press
Menu
8. Turn off and unplug the projector.

Starting the Projector With a Password

When the password function is enabled, you see this screen when you
plug in and turn on the projector:
Do one of the following to enter the password:
■ PowerLite W6 Series: Hold down the
numeric keypad to enter the four digit password.
PowerLite S6 Series or PowerLite 78: Use the numeric keypad to
■
enter a four digit password.
The password screen closes and projection begins.
If projection does not begin, check the following:
If the password is not correct, you see a message prompting you to
■
re-enter the password. If you enter an incorrect password three
times in succession, you see an error code with the message
projector's operation will be locked
to standby mode. Write down the error code, then disconnect the
projector's power cord from the electrical outlet, reconnect it, and
turn the projector back on. Try entering the correct password
again.
button and use
Num
to exit the screen.
Enter
button and use the
Num
and the projector switches
PowerLite W6 Series
note
If you leave the projector
plugged in, the Password
screen will not appear. It
appears only if you unplug
and reconnect the power
cord.
PowerLite W6 Series
The
Fine-Tuning the Projector
Hold down
Hold down
69