Dell EMC VxFlex Ready Node 13G Manual page 45

5. Repeat steps 1-4 for every node.
6. When all IP addresses are configured on all the nodes, run a sanity check:
a. Open the Windows Start menu, and select Command Prompt.
b. Ping all Data IP addresses of the other nodes to make sure you have the
correct connectivity on each node, using the command: ping x.x.x.x
(where x.x.x.x represents the Data IP address).
Results
The network configuration on the Windows node is complete. Next, perform disk
configuration procedures.
Port Configuration
Configure the ports
45