Dell tower external battery module for use with 1000w and 1920/1500w ups models getting started with your system (76 pages)
Summary of Contents for Dell PowerEdge 1550
Page 1
Dell™ PowerEdge™ 1550 and PowerApp™ 120 Systems Five-Volt Riser Board Installation w w w . d e l l . c o m | s u p p o r t . d e l l . c o m...
Page 2
Reproduction in any manner whatsoever without the written permission of Dell Computer Corpo- ration is strictly forbidden. Trademarks used in this text: Dell, the DELL logo, PowerEdge, and PowerApp are trademarks of Dell Computer Corporation. Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products.
Page 3
Dell now offers a Peripheral Component Interconnect (PCI) riser board for use with customer-furnished five-volt (5V) PCI cards. Dell does not currently support any 5V PCI cards installed in the Dell™ PowerEdge™ 1550 or PowerApp™ 120 systems. This 5V riser board is furnished for the customer’s convenience.
riser board Figure 1-1. Riser Board Removal Lift the riser board up and away from the chassis (see Figure 1-1). 5V Riser Board Installation Lower the 5V riser board into connector PCI2 on the system board, making sure that the riser board is fully seated in the connector. The 5V riser board contains a single 64-bit, 33-MHz PCI expansion-card connector.
Page 5
See the documentation that came with the card for information about cable connections. Slide the system into the rack and the top cover, and then reconnect the system and peripherals to their AC power sources and turn them on. support.dell.com riser board in connector PCI2 Five-Volt Riser Board Installation...