Fog Light Aiming - Mitsubishi Lancer Evolution 2003 Body Repair Manual

VERTICAL
ADJUSTING
VERTICAL
DIRECTION
(V)
DISTANCE OF
VERTICAL
DIRECTION
(H)
HIGH INTENSITY
ZONE
REFERENCE MATERIAL
ADJUSTMENT OF OTHER PARTS
HEADLIGHT ADJUSTMENT
1. The low beam headlight should project on the screen upper
2. If not the case, turn the adjusting screws to achieve the
AC211949 AB
HEADLIGHT
CENTER
3. When adjusting one headlight, disconnect the other
15
Do not cover a headlight for more than three minutes to
ACX01800 AB
prevent the plastic headlight lens deformation.
4. High-beam pattern should be correct when the low-beams

FOG LIGHT AIMING

PRE-AIMING INSTRUCTIONS
1. Inspect for badly rusted or faulty fog light assemblies.
2. These conditions must be corrected before a satisfactory
3. Inspect tire inflation, and adjust if necessary.
4. If the fuel tank is not full, place a weight in the trunk of the
5. There should be no other load in the vehicle other than
edge of the beam (cut-off).
specified low-beam cut-off location on the aiming screen.
Standard value:
(Vertical direction) Range of headlight center line 53 ±
50 mm (± 2.1 inches)
NOTE: There is no horizontal aim adjustment. Horizontal
aim is preset and does not require adjustment.
headlight harness.
CAUTION
are adjusted properly.
adjustment can be made.
vehicle to simulate weight of a full tank [3 kg (6.5 pounds)
per gallon.]
driver or substituted weight of approximately 70 kg (150
pounds) placed in driver's position.
8-11
M4080013000043