Power Source Operation - Cebora POWER ROD 1565 Cell Service Manual

CEBORA S.p.A.

3.2.2 - Power source operation.

System shut off and disconnected from the mains.
In MMA mode, connect the electrode clamp to the positive pole of the power source, and the
negative pole cable of the power source to the workpiece.
In TIG mode, connect the cable of the positive pole of the power source to the workpiece, the
TIG torch (Cebora torch T150 recommended) to the negative pole of the power source, and
the torch control cable to the connector (H) on the front of the power source.
In TIG mode, connect the gas supply to the specific fitting on the TIG torch.
Plug the power source into the mains and turn on the switch (F).
♦ System powered, lamp on switch (F) lit.
♦ Fan (9) running, yellow (B) and green (C) leds lit (lamp-test).
♦ Yellow led (B) off after five seconds. Voltage begins to be generated at the power
source output (without accessories connected to the connector (H), or with art.
187 connected. With the other accessories connected to the connector (H) the
power source awaits the start signal, without generating output voltage).
DURING THE TIG MODE TEST, DO NOT POINT THE TORCH AT PEOPLE OR PARTS
OF THE BODY, BUT ALWAYS TOWARDS AN OPEN SPACE OR THE WORKPIECE.
Press the start button of the accessories connected to the connector (H), if present.
♦ Voltage begins to be generated at the power source output, for as long as the
button is held down.
Use the knob (A) and the current settings of any accessories connected to the connector (H) to
adjust the welding current based on the electrode to be used, or based on the TIG welding to
be carried out.
Move the clamp with electrode or TIG torch with start button pressed near the workpiece.
♦ Begin welding. Adjust the knob (A) or the current settings of the accessories, to
maximize the welding quality.
After welding, release the start button and/or move the electrode clip or TIG torch away from
the workpiece.
♦ The welding arc is interrupted, the power source returns to its initial condition
with yellow led (B) off and green led (C) on.
3.302.113
Correct?
YES
WARNING
Correct?
YES
Correct?
YES
Correct?
YES
REGULAR OPERATION.
NO (see 3.3.1, 3.3.2, 3.3.3).
NO (see 3.3.4, 3.3.5).
NO (see 3.3.6, 3.3.7, 3.3.8).
NO (see 3.3.4, 3.3.5).
7
20/11/02