Mounting The Sensor Head - ELGO Electronic GMIX2 Series Operating Manual

7.3

Mounting the Sensor Head

To mount the sensor head, use 2 x M3 screws of adequate length.
see also section  6.2 Sensor Dimensions

During installation, the specified installation tolerances must also be adhered to:
7.3.1 Mounting Tolerances
Table 2: Mounting tolerances
Magnetic tape MB20-50-10-1-R
Sensor distance to the tape: max. 4.0 mm
Lateral offset: ± 1 mm
Tilt and pitch angle: ± 5°
Yaw angle: ± 1.5°
Sensor distance:
Pitch angle:
Yaw angle:
Figure 7: Mounting tolerances
Lateral offset:
± 1 mm
max. 4.0 mm
Tilt angle:
± 5°
± 1.5°
- 16 -
Installation and First Start-Up