Page 1
Water Washout Tester Operation and Instruction Manual REV C Koehler Instrument Company, Inc. 1595 Sycamore Avenue • Bohemia, New York 11716-1796 • USA Toll Free: 1-800-878-9070 (US only) • Tel: +1 631 589 3800 • Fax: +1 631 589 3815 http://www.koehlerinstrument.com •...
Page 3
K19201 Water Washout Tester Operation and Instruction Manual K19201-Manual...
Page 4
K19201 Water Washout Tester Operation and Instruction Manual K19201-Manual...
Page 5
K19201 Water Washout Tester Operation and Instruction Manual CERTIFICATE OF CONFORMANCE Water Washout Tester K19201 This certificate verifies that part number K19201, Water Washout Tester, was manufactured in conformance with the applicable standards set forth in this certification. Specifications: ASTM D1264...
Page 6
K19201 Water Washout Tester Operation and Instruction Manual K19201-Manual...
Page 7
Responsibility for Registration and Annual Reporting: Koehler will not sell directly to end users in the EU and so has no responsibility to register within each EU state and to make annual reports. Koehler declares that this responsibility is born by the importer who is the first level of the distribution chain and is subject to producer responsibility.
Page 8
WEEE Marking Since Koehler products are subject to the WEEE Directive we must display the WEEE symbol shown above in accordance with European Standard EN 50419 on the equipment. It must be indelible, at least 5mm in height, and clearly legible.
Providing quality testing instrumentation and technical support services for research and 3. Federal Test Method (FTM) testing laboratories has been our specialty for more than 50 years. At Koehler, the primary focus FTM Publication: of our business is providing you with the full •...
K19201 Water Washout Tester Operation and Instruction Manual 4 Descriptions Instrument Controls 12 13 Figure 3. Instrument Descriptions - Inside 7. Motor Switch. When turned on, the motor will rotate the test bearing assembly. This Figure 2. Instrument Descriptions - Front...
IMPORTANT NOTE: The digital temperature since the motor is factory calibrated. controller for the unit comes pre-programmed from the Koehler factory. Please do NOT attempt 17. Overflow and Drain Outlet. Water will flow to re-program the digital temperature controller as out of this adaptor if the water level in the bath this will void the product warranty.
K19201 Water Washout Tester Operation and Instruction Manual difference obtained in the previous step. This is 1. Timer Countdown Display. The upper red LED the offset value. display shows the time remaining for the test. c. Press the Program Key. The lower green display 2.
K19201 Water Washout Tester Operation and Instruction Manual 1. Connect the Tygon tubing to the nozzle 2. The central, larger thumbscrew secures the outlet. Place the other end of the Tygon bearing shaft and small bearing plate in place tubing into the graduated cylinder. This setup through the center of the bearing housing.
The ball bearing located in the secondary questions about maintaining your equipment, bearing housing on the motor side is greased then please do not hesitate to contact the Koehler prior to shipment. Under normal operating technical service department. conditions, the ball bearing should be...
Section 5.2. The secondary ball of the test bearing for each test. The K19201- bearing does not need to be replaced after every 03006 special gauge is used to adjust the angle test.
Temperature calibration requires use of a calibrated temperature measuring device. This 2. Turn the motor switch (Section 4.1, Item 7) to device is a part of the K19201-T-CAL-KIT the on position. The motor will then rotate the Temperature Calibration that bearing assembly.
K19201 Water Washout Tester Operation and Instruction Manual Warranty We, at Koehler, would like to thank you for your equipment purchase, which is protected by the following warranty. If within one (1) year from the 8 Service date of receipt, but no longer than fifteen (15)
Page 21
K19201 Water Washout Tester Operation and Instruction Manual products which have been used or modified in such a way that they cannot be returned to stock for future sale. -21- K19201-Manual...
Need help?
Do you have a question about the K19201 and is the answer not in the manual?
Questions and answers