The Centre Position Of The Needle In The Feeding Direction - Husqvarna VIKING E10 Service Manual

The centre position of the needle in the feeding direction

Check
1. Set the pattern selector dial to straight "A".
2. Insert a new #90 needle
3. Set the needle so the needle eye is just above the needle plate
4. The needle shall pass through the centre of the needle hole (D) in the feeding direction.
Adjustment
1. Remove the face cover.
2. Set the pattern selector dial to straight "A".
3. Set the needle so the needle eye is just above the needle plate.
4. Loosen the 2mm Allen screw (A) of needle bar supporter (E).
5. Move needle bar supporter (E) forward / backward to adjust needle.
Backward (C) - to move needle forward.
Forward (B) - to move needle backward.
6. Set the point of needle so it passes through the centre of the needle hole (D) in the feeding direction.
7. Tighten screw (A) of needle bar supporter (E).
NOTE! This adjustment affects the "Clearance between needle and hook" adjustment.
( A )
104 72 72-26
( C )
( B )
( E )
11